|
To
use Cutaway Magic:
-
Cut
a piece of the stabilizer at least one inch larger than
the hoop size you are planning to use.
-
Fuse
the entire piece of the stabilizer on to the back of
the garment using a low to medium temp, dry iron (260°F
(120°C) Silk Setting). When pressing the stabilizer
on to the garment, the iron surface should touch the
fabric, NOT the stabilizer. Use a press cloth or sheet
if necessary.
-
Hoop
the garment and place the embroidery frame on to the
machine. Complete the layout and centering of the design.
-
Important!
If the design is denser than 6,000 stitches or if it
is a poorly digitized design (too many stitches for
design size),"float" one layer of Tearaway
Magic between the hoop and the bed of the machine for
each additional 8,000 stitches for added support! After
the design is complete the tearaway can be torn away
leaving just the soft mesh against the skin.
-
After
the design is complete, remove the garment from the
machine and embroidery hoop. To remove Cutaway Magic
it may be necessary to re-heat the stabilizer and peel
it back gently to the design and trim.
*Tip!
If embroidering knit, don't forget to use topping!
*Tip! To get extra support
on large or problem designs without adding bulk, try crossing
two layers of the fusible mesh, one at 90°and the other
at 45°. This will offer a tremendous amount of stabilization
without stiffness.
**NOTE: All irons heat differently.
The iron temperature given above is a starting point. If
you find that you are not getting a good fuse, slowly increase
your irons temperature until you achieve a good bond between
the fabric and stabilizer.
Sizes
available: 12" x 10 yds, 20" x 10 yds
|
